Відео

Great stuff sir! Do you know if I can access the amplifier by just removing the rectangular trim on the left quarter panel? I am planning to add an amplifier and subwoofer and wanted to get the audio signal from the factory amp. If it requires pulling everything out, I’d rather not do it.

If the battery is dead, how do I change the battery with electric seats?

My insurance wants £50 just to update the number plate

would this work for a car with a lost key

I am mew to L405 family..all your videos are very informative... Many thanks

Hello, does anyone know the name of the sensor you removed at the 5:50 mark in the video? Thank you.

As was said before the pads should never be that tight. Unfortunately Nissan made them with little clearance. The new pads will jam in a short while, creating break drag, increasing fuel consumption, and worst uneven braking. Happened to my Navara twice until I realised what the issue was. Watch out. Solution was to file the edges of the new pad slightly to create the required clearance. My third set works properly now.

Great product and swift delivery - thank you Mr. Powerful! Does anyone have a tip to remove the original camera cover from the outside (vs. pulling down the headliner)? I can locate the tabs but I'm not able to pop them loose. Thank you!

WOW!!! What a great video, thank you!

The springy bit on the pad is the audible wear indicator I reckon. Makes a horrible noise when it hits the disc, to tell you it's time to change your pads. But clearly didn't work for you lol....

Hi, In Poland, daytime running lights cannot be on at the same time as the dipped headlights. Is it possible to completely turn off the daytime running lights when the dipped beam headlights are turned on?

I was amazed you took the filter off first..... was expecting lots more oil. I always remove the sump plug first. But it seems, on this vehicle, it doesn't matter which way round you do it :) Just bought one myself.

@powerfulukltd I wanted to check my reverse cam yesterday but I noticed that my Evoque from 2016 has a different cam holder than yours showed in the video. There is also a white holder with some kind of complicated clip which I can´t open to put the cam out the holding. Can you help me with this?

Hi folks. Super quick delivery of the rear bumper cover, but, it seems to be over 10mm too long for the bumper. I haven’t installed it yet as I can’t decide if that’s the way it was designed, or, if it was designed that length, how to fill the considerable gap on each side. In contrast, the width in the Center is perfect.

this should be a free recall.. could be downright dangerous...

What about the sun visor lights

Thanks so much you solve my problem

Great video mate!! I just got the Defender last week and guess what, the missus kept getting locked out. So she found this Video and we watch ed it twice, we were killing ourselves laughing because you’re so funny. Anyway, it worked now I won’t get a Bollocking every time she gets locked out. Cheers for that!!

😊

Any trick how to take them of if they have been on a car for years?

Could you upgrade it on l405 range rover

I added a phone power pack into the wiring config and put that above the roof liner so I have power all the time. This cable plugs into the power pack so when ignition is on the power pack gets charged and then a small usb cable to the camera

Old video I know but at 1:49 your hand covers the point where you are SUPPOSED to do the oil change. The oil is sucked out of the engine from the pipe sticking up under your hand. Twist and pull up to remove the cap, use a vacuum oil change pump to remove the oil AND THERE IS NO MESS. Some suggest removing the plug afterward to make sure all the oil is removed but this shouldn't be needed as the other end of the pipe is below the boss the plug is threaded in to.

Thank you. Couldn’t work out how to change my dud reversing light bulbs by myself.

Hi Mate, love the video. HELP re my car is needed. I'm in Perth Australia. I've got a 07 RR Sport. WITH and intermittent fault re the center console stuff and other items. Its doing my head in.............. So, I start the car, the radio works, Sat Nav and AC all work. Indicators all work. Then 3-4 or 10 minutes later, a fault comes up on the dash and the lot shuts down, NO Aircon, No Radio, No SatNav, Indicators stop working and Hazard light start flashing plus the central locking on the doors start opening and closing! Car drives normal. 3-5-10 minutes later it all switch's back on and works again as normal. THEN 5 mins later OFF again. No idea what it is................ HELP pls Thx Mark

Is it possible to increase the towing capacity on the FL2

Tried fitting these rails today to an Evoque with panoramic roof. Rails fitted without the roof fillers in but when the roof fillers were in place the allen key screws were miles out of alignment. No amount of force would let me get the bolts through to secure the rails to the mount brackets. There were also 10 metal washers with the fittings and no mention of where to use them? Any advice, thanks!

Thanks for all the effort and sharing tue knowledge mate. Is this the same for the Freelander 2?

Very helpful video! Thank you for making it! I just replaced the battery in my 2018 RRS.

Can the rear bumper lense be changed without taking the bumper off ?

Fitted mine to my Discovery 4 "Landmark" today. Took about 20 minutes or so as the covers were a bit awkward to get off as they had never been off before. The latest ones are not "smoking" anymre and are well and truly "smoked" 😂 An excellent upgrade and highly recommended as they are much clearer in daylight. My covers are the piano black ones, I would have liked to use the carbon fibre ones (like in the video) but these have disappeared from the PowerfulUK website. 😟 Update - I will say that i have a friend who got similar to these from another website - his are clearly inferior to these from PowerfulUK and, I must say, that Powerful take great care to get the best quality of the products they sell. If the price is cheaper, so likely is the quality also.

Another comment for accuracy. The front passenger door they were having trouble with having to slide the panel off was not because of any other reason other that THESE were the ORIGINAL BLACK ONE PIECE factory clips and STRONG AS HELL. They usually snap off when the moulding is removed and you replace them with the white and yellow bastard clips I have mentioned before, So this video although informative is not showing you a typical removal of the mouldings from a vehicle that would come with the FACTORY mouldings. If so all the clips would be BLACK. This vehicle in my opinion has had the mouldings off before and the two BLACK clips were the only ones that SURVIVED being removed and were re used. Now you can see just how strong the BLACK clips really are. They stay behind on the door or break off. The white and yellow clips separate into the white part and yellow part left in the door. Good luck to you all.

Further update....The original mouldings from factory come with a BLACK one piece clip and you cannot buy them seperately. The white and yellow two piece clip is the Range Rover revision clip and it is USEL:ESS. Most are loose and do not hold together properly at the best of times and in fact the two parts separate with little effort causing your mouldings to potentially fall off. I have found the only way to stop this is to bond the two pieces togther with a high strength industrial glue so the clip becomes as one not two parts then it essentially acts like the original clips again. I had the whole side of my vehicles mouldings replaced and these two part clips of which many were so loose you could pull them apart with little effort had to be glued together to make the mould strong enough to stay on the car. Range Rover did a woeful job when they changed this part from the original one piece BLACK click to the two piece white and yellow clip and it has caused me no end of problems. My advice to anyone who can even get the origninal OEM mouldings anymore as they are becoming rare now is to use something like Q Bond super Glue with the graphite powder as a bonding agent to bond the two part clips together. Glue on it's own is not strong enough. As the mouldings are $100's each you really want them to try and get them to stay on your car if possible when your driving and not fall off at 100Km/h ......What an absolute mess Range Rover. Great video PowerfulUKLTD

You guys are the best

Hi, if I bought this watch used can I program it to my defender ?

I have the larger screen in my current 90, I’m not fan, it looks like an afterthought and everything is still the same size as the 10” screen, which to me looks much tidier.

When will the easy brackets be available? The only thing that bothers me about my Defender is the small screen!

When will you be offering the wiring loom, I just bought all the brackets from you.

Did you ever get a product for the front grill (item 7) in the video :) ….

Thank you !

Hi, can you unlock radio A441 Thanks

Is this safe?

Hi Simon, Always interested to see how you work on the cars, can you give me some advise for following If you don't mind: Is the same air vent size is on disco sport 2020 and looks like same size on disco 5? I want to find bumper air vent to suit my disco sport 2020 with three fins instead of 2 same as 2024 DS model. Do you have those on sale? Thank you

Thank you!

What about the genuine function like TV and rear entertainment screen? They are working? Anyone find a similar product what all function works? Thank you

Looking forward to those magsafe/centre console switch mount bits whenever they're ready!

Dear sir ,your very humble person ❤

Great option! Do you have a solution for us that conceal carry and need a holster placement in the cab? Maybe at knee level (left and Right side driving) US asking, of course.

Another quality product backed by superb service. Love buying my evoque bits and pieces from PowerfulUK.